beautypg.com

MTD E640F User Manual

Page 6

background image

6

SECTION 5: ASSEMBLY INSTRUCTIONS

IMPORTANT:

After assembly, service engine with

gasoline, and check oil level as instructed in the
separate engine manual packed with your unit.

NOTE:

All references to right or left side of the

snow thrower are determined from behind the unit in
the operating position.

UNPACKING

• Remove staples or break glue on the top flaps

of the carton. Remove any loose parts
included with unit (i.e., Operator’s Manual, etc).

• Cut along dotted lines and lay end of carton

down flat. Remove packing material.

• Roll unit out of carton. Check carton

thoroughly for loose parts before discarding.

TOOLS REQUIRED FOR ASSEMBLY

• (1) 3/8" Wrench

• (2) 7/16" Wrench*

• (2) 1/2" Wrench*

• 9/16” Wrench

• Pair of pliers

*or adjustable wrench

LOOSE PARTS IN CARTON See Figure 3

Figure 3

A

(2)

Handles (Right and Left)

B

(1)

Handle Panel Assembly

C

(1)

Chute Assembly

D

(1)

Chute Crank Assembly w/ Upper
Mounting Bracket

E

(1)

Shift Rod

(1)

Hardware Pack (not illustrated)

A

B

C

D

E

This manual is related to the following products: