Micon IP-220E - Manual (Page 8)

7
Chapter 3: Hardware Installation
3.1 Installation Procedure
Step 1:
Connect one end of the
Ethernet cable to any
available port on your hub,
router, or cable/dsl modem.
Step 2:
Plug the other end of the
Ethernet cable to the
network port on the iGuard
IP-220E.
Step 3:
Connect DC power adapter
output into iGuard IP-220E
socket.
Warning:
Please make sure the input Voltage and Frequency of the DC power adapter (DC
5.3V) is correct before plugging into the power outlet!