beautypg.com

Parent unit power supply – Motorola MBP36 User Manual

Page 9

background image

Getting Started

9

ENG

L

ISH

2.3

Parent Unit Power Supply

IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event
of a power failure.
1. Connect the small plug of the power adapter to the parent unit and

the other end to the electrical outlet. Only use the enclosed power
adapter (6V DC/500mA).

2. Press and hold the

P

POWER ON/OFF button for 1 second to

turn ON the parent unit.

3. Once the baby and parent units are switched on, the display on the

parent unit will show the video captured by the baby unit.

4. If there is no connection or you are out of range, the video display

will go off and the words

No Signal

will be shown on the LCD display,

and the unit will beep every 5 seconds. Move the parent unit closer
to the baby unit until the link is re-established.

5. Press and hold the

P

POWER ON/OFF button, until the progress

bar finishes scrolling, to turn OFF the parent unit.

NOTE
The battery icon

turns RED to indicate that the battery is low, and it

gives a beep every 16 seconds. The battery needs to be recharged. The
battery pack takes about 16 hours to charge fully.
When charging
1.
During power OFF, when adapter is plugged in, a adapter logo will

display on screen and then a flashing battery logo will display for 45 sec.
The Blue LED at top left corner light up indicates adapter is plugged in.

0