Mellerware 3 5 5 3 0 User Manual

Page 5

5.) ANTI-FREEZE SETTING

Press the “power setting” button and it is recommended
to select the maximum power level. Set the temperature
to 5˚C with the “-“ button. When set this way, the
appliance will switch on automatically only if the room
temperature falls below 5˚C, to prevent freezing at
minimum energy consumption.

6.) USING OF BOOKING TIMER

NOTE: If you want to operate the appliance in the auto
mode, press the button “booking timer” to activate it.
I In this mode, the function of the timing will be
i invalidated.

Press the button “booking timer” one or more times
within 5 seconds to select the booking timing mode, as
per the following sequence:

The booking timing mode setting can be circulated as
above sequence and the yellow timing pilot light will be
on during the heater operating in auto mode.

a. Auto on

When the LCD shows “AUTO ON”, the unit comes into
auto power on timing state. To select what time you
require the heater to be on, push the button “hour”
and “minute” until your required operating time appears.

b. Auto off

When the LCD shows “AUTO OFF”, the unit comes into
auto power off timing state. To select what time you
require the heater to be off, push the button “hour”
and “minute” until your required operating time appears.

The operating time has a span of 24 hours. Auto on and
auto off default value is ”00:00”.

c. Auto

Press the button “booking time” until the LCD appears
“AUTO”. This indicates that the auto mode comes into
effect. The yellow timing pilot light now lights up.

During operating in the auto mode, you can use the
“+” button or “-” to set the desired comfort temperature
as described above and the appliance will
automatically switch on or off at the preset time
and automatically maintain the preset comfort
temperature.

NOTE: Do not press the button “power setting” when
operating in the auto mode, this will cancel the function
of “booking timer”.

To cancel the function of “booking timer”, press the
button “booking timer” until blank appears and wait for
5 seconds or press the button “power setting”, the
yellow timing pilot light will go out.

NOTE: To keep the heater’s memory programmed,
always leave the heater plugged in at the mains
socket. If the heater looses its electricity supply, e.g.
switched off at the mains socket or in the event of a
power failure, the heater’s programs will be lost, and
the heater will not work until reset.

This heater includes an overheat protection system
that shuts off the heater when parts of the heater
are getting excessively hot. Once it occurs, the heater’s
programs will be lost.

To completely shut the heater off, turn the controls and
power to OFF, and remove plug from the socket-outlet.

AM AUTO ON

AM AUTO

PM AUTO ON

AUTO ON

AUTO

BLANK

AUTO OFF

OFF

MAX