Motorola DSR530 - Manual (Page 13)

CONNECTING YOUR DSR
11
Modem: Connect the telephone jack to a home telephone jack for Instant Pay-Per-View (IPPV)
reportback and Caller ID. Star Choice will not permit IPPV unless this remains connected.
Ant In: If applicable, connect the external antenna input for local off-air or cable TV broadcast. The DSR
will pass-through this RF source to the RF Output Connection when the DSR is in standby mode.
Once the above connections are secure, plug the DSR power cord or separate power supply (in the
case of the DSR207) into a standard power outlet. Wait one minute, and then press the ON button
located on the satellite receiver’s front panel.
Notes:
Video and audio quality should be best when you connect the DSR directly to your TV/monitor/projector
and an optional audio system. Use quality cables designed for these applications. Home theater A/V
receivers can provide a method to connect multiple input sources if your TV does not have enough
input connectors, and some home theater A/V receivers may enhance the video resolution or quality.
Refer to your home theater A/V receiver instructions for further information.
If you are using the component or DVI video outputs, you may have to toggle the HDTV mode select
button behind the flip-down door on the front panel of a DSR5xx series product. This toggles the HDTV
output between 1080i, 720p, 480p, 480i, and native modes. Native mode (0000) is the original
transmitted signal from the network/broadcaster. You should leave this on native mode unless your TV
or monitor requires a specific mode, such as 1080i.