Metrologic Instruments MX003 - Manual (Page 22)

18
M ATCHING P ROCEDURE
With the MS6130, scan the following bar codes starting from the top down:
Transmitter Enter/Exit Program Mode
* *
Recall Defaults
D F 1
Enable RF Communications
R 3 5
Transmitter Enter/Exit Program Mode
* *
Locate the model label on the case of the receiver. Scan the serial number
bar code.
The receiver and MS6130 are now matched.
For information on how to configure the receiver, refer to the appropriate
section in this guide.
Note: If using more than one MS6130 with one receiver, perform the
above procedure for each MS6130. Since each MS6130 has the
same ID number, the receiver will accept data from all of the
scanners