beautypg.com

Warning, Starting/stopping instructions, Starting position – MTD Y765 User Manual

Page 9: Starting instructions stopping instructions

background image

9

STARTING/STOPPING INSTRUCTIONS

Fig. 6

Starting
Position

Start/On (I)

Stop/Off (O)

Starter Rope

Throttle Control

Fig. 8

Fig. 7

Blue Choke

Lever

Position

1

Position

3

Position

2

Primer Bulb

Operate this unit only in a
well- ventilated outdoor

area. Carbon monoxide exhaust fumes can be lethal in
a confined area.

WARNING:

Avoid accidental starting.
Make sure you are in the

starting position when pulling the starter rope (Fig. 8).
To avoid serious injury, the operator and unit must be
in a stable position while starting.

WARNING:

STARTING INSTRUCTIONS

STOPPING INSTRUCTIONS

1. Release your hand from the throttle control. Allow the engine

to cool down by idling.

2. Put the On/Off Stop Control in the OFF (O) position.

1. Mix gas with oil. Fill fuel tank with fuel/oil mixture. See

Oil and Fuel Mixing Instructions.

2. Make sure the On/Off Stop Control in the ON ( I )

position (Fig. 6).

3. Fully press and release the primer bulb 10 times,

slowly. Some amount of fuel should be visible in the
primer bulb and fuel lines (Fig. 7). If you can’t see fuel in
the bulb, press and release the bulb as many times as it
takes before you can see fuel in it.

4. Place the blue choke lever in Position 1 (Fig. 7).

5. Crouch in the starting position (Fig. 8) and squeeze the

throttle control. Pull the starter rope out with a
controlled and steady motion 5 times.

NOTE: The unit uses EZ-Pull Version 3™, which significantly

reduces the effort required to start the engine. You
must pull the starter rope out far enough to hear the
engine attempt to start. There is no need to pull the
rope briskly-- there is no harsh resistance when
pulling. Be aware that this starting method is vastly
different from (and much easier than) what you may
be used to.

6. Place the blue choke lever in Position 2.

7. While squeezing the throttle control, pull the starter

rope out with a controlled and steady motion until the
engine starts.

8. Keep the throttle squeezed and allow the engine to

warm up for 15 to 30 seconds.

9. Place the blue choke lever in Position 3. The unit is

ready for use.

NOTE: Move the blue choke lever to Position 3 for best

engine performance. DO NOT leave the lever in
Position 2.

IF...

The engine does not start, go back to step 3.

IF...

The engine fails to start after a few attempts, place
the blue choke lever in Position 3 and squeeze the
throttle control. Pull the starter rope 3 to 8 times. The
engine should start. If not, repeat.

IF WARM...

If the engine is already warm, make sure the

On/Off Stop control is in the ON position and start the
unit with the blue choke lever in Position 2. After the
unit starts, move the blue choke lever to Position 3.