MTD CC4125 / CC4175 - Manual (Page 3)

3
RULES FOR SAFE OPERATION
SAFETY AND INTERNATIONAL SYMBOLS
This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the
operator's manual for complete safety, assembly, operating and maintenance and repair information.
SYMBOL MEANING
• ON/OFF STOP CONTROL
ON / START / RUN
• WARNING - READ OPERATOR'S MANUAL
Read the operator’s manual(s) and follow all warnings
and safety instructions. Failure to do so can result in
serious injury to the operator and/or bystanders.
• ON/OFF STOP CONTROL
OFF or STOP
SYMBOL MEANING
• SAFETY ALERT SYMBOL
Indicates danger, warning or caution. May be used
in conjunction with other symbols or pictographs.
• WEAR EYE AND HEARING PROTECTION
WARNING: Thrown objects and loud noise can
cause severe eye injury and hearing loss. Wear eye
protection meeting ANSI Z87.1 standards and ear
protection when operating this unit. Use a full face
shield when needed.
• KEEP BYSTANDERS AWAY
WARNING: Keep all bystanders, especially
children and pets, at least 50 feet (15 m) from the
operating area.
• THROWN OBJECTS AND ROTATING CUTTER
CAN CAUSE SEVERE INJURY
WARNING: Do not operate without the cutting
attachment shield in place. Keep away from the
rotating cutting attachment.
• HOT SURFACE WARNING
Do not touch a hot muffler, gear housing or cylinder.
You may get burned. These parts get extremely hot
from operation. They remain hot for a short time after
the unit is turned off.
• UNLEADED FUEL
Always use clean, fresh unleaded fuel
• OIL
Refer to operator’s manual for the proper type of
oil.
• SHARP BLADE
WARNING: Sharp blade on cutting attachment
shield. To prevent serious injury, do not touch the
line cutting blade.
• PRIMER BULB
Push primer bulb, fully and slowly, 10 times.
KNOW YOUR UNIT
Primer
Bulb
Oil Fill
Plug/
Dipstick
Spark Plug
Air Filter Cover
CC4175
Cutting
Attachment
Shield
CC4125
Line
Cutting
Blade
Cutting
Attachment
Shield
Fuel
Cap
Throttle
Control
J-Handle
Cutting Attachment
Shaft Grip
On/Off Stop
Control
Shaft
Housing
Starter Rope Grip
Line
Cutting
Blade
APPLICATIONS
As a trimmer:
• Cutting grass and light weeds
• Edging
• Decorative trimming around trees, fences, etc.
Other optional accessories may be used with your unit.
Refer to Operating the Rapid-Link System for a list of add-
ons.
NOTE: The below illustration may differ slightly from your
unit. For example, the picture shows a straight shaft.
Your unit may have a curved shaft.
Muffler
Spark Arrestor
Cutting
Attachment
Muffler Guard
Rapid-Link™