Morphy Richards Filter rapide kettle - Manual (Page 4)

Using
Filtering your water improves the taste
and appearance of beverages by reducing
limescale, lead, chlorine and other
impurities.
Before use
1 Remove cartridge from the packet, place
in a bowl of water and shake.
2 Take the top compartment (the cartridge
holder) out of the kettle by pulling the
cartridge holder easy release button
Ë
forward and lift upwards. A
3 Ensure the filter seal is in place. B
4 Insert the cartridge into the top
compartment from the bottom and twist
clockwise to lock in place.
C
5 Replace the cartridge holder back into
the kettle and click into place.
Filling the kettle
1 Fill the kettle with tap water to the
maximum mark either by lifting up the lid
D or by sliding the filler slider to one
side as shown.
E
2 Allow water to filter through system.
When using for the first time discard the
water and repeat once more.
The amount of water must cover
the kettle element. The minimum is 1
cup or 30 cls. Do not fill above the
maximum mark or filter performance
will be impaired. Always ensure the
kettle is emptied before refilling.
Electronic cartridge
reminder
Certain models only
After changing the cartridge and for first
usage, the counter must be reset.
1 Hold the start button for 3 seconds
(100% will show on the display and the
outer ring will flash).
F The display will
then switch off due to its energy saving
device after 3 minutes.
2 You can check the progress of your
cartridge at any time by pressing the
start button for 1 second. The counter
will count down from 100% to 25%.
3 25% turns off when the cartridge needs
replacing. The outer ring of the display
will flash and continue to flash until the
cartridge has been changed.
G
4 Reset the reminder as per point 1.
4
A B
C D
E F
G
43550 Filter kettle Rev 5 21/3/05 3:03 PM Page 4