Connections to be made – Metra Electronics CHTO-013 User Manual

Page 3

From the 16-pin harness:
• Connect the

Red wire to the ignition wire of the aftermarket radio.

• Connect the

Orange/White wire to the illumination wire of the aftermarket radio.

If the aftermarket radio has no illumination wire just tape off the

Orange/White wire.

• Connect the

White wire to the left front positive speaker output of the aftermarket radio.

• Connect the

White/Black wire to the left front negative speaker output of the

aftermarket radio.

• Connect the

Gray wire to the right front positive speaker output of the aftermarket radio.

• Connect the

Gray/Black wire to the right front negative speaker output of the

aftermarket radio.

• Connect the

Green wire to the radio’s left rear positive speaker output.

• Connect the

Green/Black wire to the radio’s left rear negative speaker output.

• Connect the

Purple wire to the radio’s right rear positive speaker output.

• Connect the

Purple/Black wire to the radio’s right rear negative speaker output.

• Connect the

Blue/White wire to the radio’s amp turn on wire.

• Connect the

Brown wire to the mute wire of the aftermarket radio. If the aftermarket

radio does not have a mute wire, tape up the

Brown wire.

• Connect the

Light Green wire to the parking brake wire of the aftermarket

navigation radio.

• Connect the

Blue/Pink wire to the VSS or speed sense wire of the aftermarket

navigation radio.

• Connect the

Green/Purple wire to the reverse wire of the aftermarket navigation radio.

• Plug the 16-pin harness into the CHTO-013.

Connections to be made

CHTO-013