Milan Technology MIL-S801XX - Manual (Page 7)

MIL-S801XX switch with ST fiber port
Figure 2-3. The Front Panel of the MIL-S801XX switch with ST fiber port
MIL-S801XX switch with MT-RJ fiber port
Figure 2-4. The Front Panel of the MIL-S801XX switch with MT-RJ fiber port
MIL-S801XX switch with VF-45 fiber port
Figure 2-5. The Front Panel of the MIL-S801XX switch with VF-45 fiber port
RJ-45 Ports (Auto MDI/MDIX): Eight auto-sensing for 10BASE-T or
100BASE-TX connections.
In general, MDI means connecting to another Hub or switch while MDIX
means connecting to a workstation or PC. Therefore, Auto MDI/MDIX means
that you can connect to another switch or workstation without changing
cabling.
100BASE-FX Port: There are 4 types of fiber connectors available for the
MIL-S801XX switch as shown above. The distance for multi-mode fiber
cabling can be extended up to 2 kilometers. However, the distance for SC
single-mode fiber port is from 15 to 60 kilometers.
DIP-switch: the DIP-switch is to select Full-Duplex or Half-Duplex mode for
fiber port.