Metra Electronics Automobile Parts - Manual (Page 7)

• Long flashes represent the wire(s) that are connected to the interface
• 3rd led flash is the Green/Orange wire on the interface
• 5th led flash is the Black/Green wire on the interface
If during the auto detect sequence there was no long led flash, just
short ones, the interface was not connected to the correct wire on the
ASWCSTALK or the incorrect wire was used on the interface.
The 2nd set of led flashes represents what brand radio the interface
believes it is connected to. Each flash is for a different radio manufacturer.
For example if you are installing a JVC radio the interface should blink 5
times.
1st led flash is for Eclipse
2nd led flash is for Kenwood
3rd led flash is for Clarion
4th led flash is for Sony and Dual
5th led flash is for JVC
6th led flash is for Pioneer and Jensen
7th led flash is for Alpine*
8th led flash is for Visteon
9th led flash is for Valor
10th Clarion 5V
* Note: If the interface flashes 7 times and you do not have an Alpine
radio connected to it that means that the interface did not see any radio
connected. Verify the 3.5mm connector is connected to the SWC input on
the radio.
5