Marshall Amplification Guv'nor Plus GV-2 - Manual (Page 4)

5 4
ENGLISH
amount of bass will generally make your tone warmer and thicker
at the bottom end.
4. Deep
This adds an active resonant bass boost to your tone in a way that
can’t be replicated with traditional tone controls and has a similar
effect to the acclaimed JCM2000 “Deep” switch. Increasing the
amount of Deep will add masses of tight bottom end to your tone
giving it real low end resonance and incredible fullness.
5. DC Input
For input of a 9V DC negative regulated power supply should you
not wish to use batteries.
6. LED
Indicates when the Guv’nor Plus is in operation.
7. Treble
Adjusts the high end frequencies in your tone, an increase making
it brighter, sharper and more cutting.
8. Mid
Adjusts the middle frequencies in your tone. Adding more middle
will fill out your sound and make it fatter. By reducing the amount
of middle in your tone you will make it thinner and sharper.
Cranking the gain (item 2) up and setting the Mid control to
minimum will deliver “scooped” sounds, ideal for brutal crunch
tones.
9. Volume
Adjusts the volume of the Guv’nor Plus. This allows you to cut or
boost your volume when you switch the pedal on and is ideal for
switching from rhythmn to higher volume solo levels. The Volume
levels of the Guv’nor Plus are greater than previously available on
the original Guv’nor to allow you to push the front end of your
amp harder for even more overdrive.
10. In Jack
This is the input jack, for connection directly from your guitar or to
another effects pedal if you are linking pedals together.
11. Foot Switch
For switching the Guv’nor Plus on and off.
WHAT IF
NO
OUTPUT
SOUND TOO
TREBLY OR
FIZZY
UNUSUAL
HUM
BASS
FEEDBACK
SOUND TOO
MUSHY OR
BASSY
UNUSUAL
FEEDBACK
INDICATOR
LED NOT
ON
NOISE IN
BYPASS
CHECK BA
TTER
Y
CHECK LEADS CHECK PEDAL CONTROLS DC INLET CHECK AMP CONTROLS CHECK GUIT
AR
REDUCE
TREBLE
REDUCE
TREBLE
INPUT
LEAD
Trouble Shooting
✓ ✓
✓
✓
✓
✓
✓
✓ ✓ ✓ ✓
✓
✓ ✓ ✓
✓
✓
✓ ✓
✓ ✓ ✓
MOVE AWAY
FROM AMP
PICKUPS
MAY BE
VIBRATING