Morphy Richards Beech stainless steel kettle - Manual (Page 4)

Using
1 Please note that this kettle does not have
an opening lid, fill through the spout,
with the filter in place this helps to free
the filter from limescale build-up.
• The integrated water level indicator
allows you to easily see the amount of
water in the kettle.
• Always ensure that enough water is in
the kettle to see the level through the
water level indicator.
• Boil only as much water as you need as
this saves electricity.
2 Place the kettle on the base unit,
ensuring the kettle locates on to the
360˚ connector.
• The 360˚ connector allows the kettle to
be located at any position. - ideal for left
and right handed users and for
convenient positioning on worktop.
3 Plug in and switch on at the wall socket.
4 Switch the kettle on using the on/off
switch and the ‘power on’ neon will light
up.
5 When the water boils the kettle will
switch off automatically.
• If you are using the kettle for the first
time, pour away the boiled water and
refill.
6 Lift the kettle from the base unit by the
handle ensuring you hold the kettle level.
• To re-boil, switch to ON again. If the
kettle has just switched off wait a minute
or so before switching it back on again.
• If you do not put in enough water, or
switch on the kettle when it is empty, the
safety cut-out will switch off the power
automatically. If this happens, refill and
wait a few minutes for the element to
cool, then use as normal.
Filter removal
1 Pull the filter forwards and lift the filter
upwards to remove.
2 To refit the filter, slide it into the side wall
guides of the filter holder until it clicks
into place. Ensure the filter is correctly
located.
WARNING: Unless the filter is fitted
correctly, the kettle may not switch off
after boiling.
4