beautypg.com

Microtek Artix Scan1100 User Manual

Artixscan 1100 hardware user’s guide

Microtek Artix Scan1100 User Manual | 39 pages Microtek Artix Scan1100 User Manual | 39 pages
Table of contents

Document Outline

  • Contents
    • 1 Introduction
    • 2 General Installation
    • 1. Unpacking the Scanner
    • 2. Unlocking the Carriage
    • 3. Resetting the scanner's SCSI ID
    • 4. Power-up test
    • A. Operating Voltage
    • B. Connecting the Scanner to Power Source
    • C. Powering up the Scanner
    • D. Observing the Scanner Boot Process
    • 5. Choosing the Scanning Station
    • Requirements for the Operating Environment
    • 3 Installation on the Macintosh
    • A. Installation for Macintosh computers with built-in SCSI ports
    • B. Installation for the new G3 Macintosh computers
    • 4 Installation on Windows 98 / 95
    • 1. Installing the interface card
    • 2. Checking the interface card status
    • 3. Installing the software
    • 4. Connecting the scanner
    • 5. Termination
    • 6. Troubleshooting
    • 5 Installation under Windows NT 4.0
    • 6 Operating the Scanner
    • 1. Positioning reflective materials
    • A. General scanning
    • B. Scanning thick documents
    • 2. Positioning transparent film
    • A. Using the Universal Glass Film Holder
    • B. Using the 35mm Slide Holder
    • C. Using the 35mm Filmstrip Holder
    • D. Using the 6 x 9 cm Film Holder
    • E. Using the 4" x 5" Film Holder
    • 7 Using the Scanner ICC Profiler Program
    • 1. Introduction
    • 2. Calibration target
    • 3. Taking care of the target
    • 4. Replacing the target
    • 5. Installing the Scanner ICC Profiler
    • A. For the Macintosh
    • B. For Windows 98 / 95 / NT 4.0
    • 6. Placing the color target
    • 7. Calibration
    • 8. Scanning the target image
    • 9. Aligning the target registration marks
    • A. Aligning the upper-left registration mark
    • B. Aligning the upper-right registration mark
    • C. Aligning the bottom-right registration mark
    • 10. Creating a profile 29
    • 11. Reference Section for Macintosh
    • A. Menu commands
    • B. The Main Window
    • C. The Calibration Window: Preview and Scan
    • D. The Calibration Window: Aligning targets and creating the profile
    • 12. Reference section for PC
    • A. The Main Window
    • B. The Calibration Window: Preview and Scan
    • C. The Calibration Window: Aligning targets and creating the profile