Maytag MBV1976AA - Manual (Page 6)

5
STEP 3 – Install Shelves
STEP 2 – Level the Stand Stand Assembly
Carefully unpack the stand parts (see below) from the
packaging.
Tools Needed:
• #2 phillips head screw driver • Level
• Adjustable Wrench
Parts Quantity
A End Frame.......................................................................................................2
B Long Support Rail.......................................................................................4
C Rear Leveling Legs (attached to end frames)..............................2
D Shelves..............................................................................................................2
E Pan-Head Screws.....................................................................................24
F Left Side Panel (with hinge holes) .....................................................1
G Right Side Panel (with no hinge holes)...........................................1
H Back Panel......................................................................................................1
I Door....................................................................................................................1
J Hinges (attached to the door)..............................................................2
K Front Foot.........................................................................................................2
L M5 x 16 Hex-Phillips Head Cap Screw - 5 ⁄
8
” (16mm) long....6
M Front Foot Leveling Head ........................................................................2
N Flat Head Screws.........................................................................................6
FF M5 x 20 Hex-Phillips Head Cap Screw - 3 ⁄
4
” (20mm) long....2
C
STEP 1 – Assemble Frame of Stand
A
B
K
M
L
x 3
K/M