MaxTech XT7800 - Manual (Page 5)

4
on the computer.
• Connect the supplied power cord into the AC connector on the back
of the monitor and the other end into an AC outlet.
• The monitor is now ready for use.
Section 3 - Monitor Controls and LEDs
1. Power Indicator
LEDs A, B, and C (See Figure 3-1) indicate the operational state of the
monitor.
1.1 LEDs A, B and C are lit: The monitor is in normal operating
mode.
1.2 Only LEDs B and C are lit: The monitor is in the power saving
“SUSPEND” mode. In this mode the monitor uses only 25W. The
screen is blank.
1.3 Only LED C is lit: The monitor is in the power saving “OFF”
mode. The monitor is in minimum power state and uses only 5W.
The screen is blank.
1.4 All LEDs are off: The power switch is off.
2. Degaussing Control
Press to clear color impurity of the display.
3. Power Switch
Press to turn the monitor on. Press again to turn the monitor off.
4. Brightness Control
Adjusts the display brightness.
A
B
C
1
12
(on back)
Figure 3-1 Controls and LEDs
2 4 5 6 7 8 9 10 11 3