Magnadyne MARKSMAN X11 - Manual (Page 15)

1. Press the button twice on the remote transmitter.
2. The parking lights will turn “ON” to indicate the remote start command has been received.
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, the parking lights will turn back on to indicate climate controls are
activated to your presettings (While the vehicle is running, the “minute” digits will appear
flashing on the LCD screen of the transmitter. It will indicate the count down timer based on
the 5, 10, 20 or 30 minute run time set up by your installation center).
5. The vehicle will run for 5 to 30 minute cycles and automatically shut down (When the unit
shuts off the count down timer will turn off and the transmitter will play a melody tune).
Note: The Remote Start unit will not start if any of these conditions exist:
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to “OFF” position (if installed).
4. The gear selector is in any gear other than “Park” or “Neutral”.
(Child Safety Mode):
The factory default setting to remote start your vehicle is to press the button twice. If the child
safety mode has been activated, press the and the buttons at the same time to remote start
the vehicle.
1. Insert the Ignition key, turn it to the “ON” position “NOT THE START POSITION”.
2. Press the brake pedal.
Note: If the Brake Pedal is pressed before the key is in the “ON” position, the engine will
automatically shut off.
Remote Start Operation
To Remote Start Your Vehicle by Using the Remote Transmitter
To Operate the Vehicle While in the Remote Start Feature
Safe Start
15
As with any product that performs automatic functions, there are certain safety precautions that
you must practice and be aware of.
1. Keep the transmitter out of reach of children.
2. DO NOT leave anyone in the vehicle while running on remote control.
3. Alert any service personal that the vehicle can be started automatically.
4. DO NOT start the vehicle by remote while it’s in an enclosed area or garage.
5. Always apply the parking brake and lock the vehicle as you exit the vehicle.
6. Should the unit malfunction, disconnect the fuse until the problem is corrected.
7. The use and operations of this security system is the sole responsibility of the
owner/operator of the vehicle.
8. Some areas may have local ordinances that prohibit leaving a vehicle running on public
streets. Check your local laws and ordinances.
User Warnings