Murray 22" Push - Manual (Page 14)

PREPARATION
14 F-040417L
MODELS WITH OPTIONAL GRASS BAG
HOW TO MOUNT
THE GRASS BAG
1. To mount the grass bag on the mower,
raise the rear door. Hold the handle of the
grass bag. Put the grass bag in the
operating position (Figure 11). Lower the
rear door.
IMPORTANT: Make sure the hooks, on each
side of the frame assembly, are mounted
on the pivot rod.
WARNING: Do not use the grass
bag unless the cover is in the op-
erating postion.
Figure 11
Mount Frame
Hooks To Pivot Rod
Handle Bracket
Handle
Rear Door
HOW TO EMPTY THE GRASS BAG
WARNING: Before you remove
the grass bag, stop the engine.
Before you remove any grass
from the mower housing,
disconnect the wire from the
spark plug.
1. Hold the rear door. Raise the rear door to
a vertical position (Figure 11).
2. Lift the frame assembly over the two
handle notches.
3. Open the top cover (Figure 12). Empty the
grass from the grass bag.
4. To mount the grass bag on the mower, see
“How To Mount The Grass Bag”.
ОООООО
ОООООО
ОООООО
ОООООО
ОООООО
Figure 12
Top Cover
Grass Bag