Marantz MS308 - Manual (Page 3)

For safety reasons please read the following instructions and the enclosed
Important Safety Information carefully before attempting to connect your
subwoofer unit to the mains.
Use of controls or adjustments or performance of procedures other than
those specified may result in hazardous radiation exposure.
The lightning flash with the arrowhead symbol within an
equilateral triangle is intended to alert the user to the presence
of uninsulated ‘dangerous voltage’ within the product’s
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature
accompanying the appliance.
This product complies with European Low Voltage
(73/23/EEC) and Electromagnetic Compatibility
(89/336/EEC) Directives when used according to this
instruction manual.
The 110V version of the MS308 complies to the requirement
Warning
To reduce the risk of fire or electric shock, do not expose this appliance to
rain or moisture.
Caution
Caution
To reduce the risk of electric shock, do not remove cover (or back). There
are no user-serviceable parts inside. Please refer all servicing to a
qualified engineer.
ANSI/UL STD.1492, is certified to CAN/CSA STD.C22.2
NO.1 and is approved by ETL for sale in the USA and Canada
Plug Fitting Instructions (UK only)
The cord supplied with this appliance is factory fitted with a 13A mains plug
fitted with a 3A fuse inside. If it is necessary to change the fuse, it is
important that a 3A one is used. If the plug needs to be changed because it
is not suitable for your socket, or becomes damaged, it should be cut off
and an appropriate plug fitted following the wiring instructions below. The
plug must then be disposed of safely, as insertion into a 13A socket is likely
to cause an electrical hazard. Should it be necessary to fit a 3-pin BS
mains plug to the power cord the wires should be fitted as shown in this
diagram. The colours of the wires in the mains lead of this appliance may
not correspond with the coloured markings identifying the terminals in your
plug. Connect them as follows:-
• The wire which is coloured BLUE
must be connected to the terminal
which is marked with the letter ‘N’
or coloured BLACK.
• The wire which is coloured
BROWN must be connected to the
terminal which is marked with the
letter ‘L’ or coloured RED
• The wire which is coloured
G R E E N / Y E L L O W m u s t b e
connected to the terminal which is
marked with the letter ‘E’ or
coloured GREEN.
Note
If a 13 Amp (BS 1363) type of plug is used a 3 Amp or 5 Amp fuse must be
fitted, either in the plug or adaptor, or on the distribution board.
E GREEN /
YELLOW
BLUE
FUSE
BROWN
CORD
GRIP
N
L
Safety Precautions
3