Matrox Electronic Systems LE G450 - Manual (Page 27)

Matrox Graphics Card – User Guide 27
3 Cause You may be using BNC connectors with a Plug-and-Play monitor. The Plug-and-Play feature
of a monitor can’t be used with BNC connectors.
1 Solution If there’s an HD-15 connector at the back of your monitor, use this connector instead of the
BNC connectors.
Problem After game for Windows 98/Me/2000/XP starts,
monitor doesn’t display properly
(blank screen, rolling or overlapping screen images)
1 Cause If your game uses a low-resolution (640 × 480 and below), full-screen display mode, your
monitor may not support the refresh rate the Matrox driver is using.
1 Solution 1 If the game is still running in full-screen mode and your monitor is unusable, exit the
game. To do this, press [Alt]+[Tab] once, right-click the name of the game on the
Windows taskbar, then click
Close .
2 Make sure the correct monitor is selected in Windows ( see “Monitor setup”, page 9 ).
2 Solution 1 If the game is still running in full-screen mode and your monitor is unusable, exit the
game. To do this, press [Alt]+[Tab] once, right-click the name of the game on the
Windows taskbar, then click
Close .
2 Access the Matrox PowerDesk Monitor Settings property sheet ( see “Accessing
PowerDesk property sheets”, page 9 ).
3 Click Select customizations from the Matrox list .
4 From the Matrox monitor list, select the monitor model you’re using. If your monitor
model doesn’t appear in the list, select a monitor that runs at 60 Hz at 640 × 480 (for
example,
Standard monitor types # Vesa 1024X768 @60Hz # Next ). Follow the on-
screen instructions to complete the selection.
HD-15 connector BNC (Bayonet Nut Connect)
connectors