MIDLAND WR300-301 Owner Manual - Manual (Page 8)

WR-300/301 Owner’s Manual
Page 8 www.midlandradio.com
Programming S.A.M.E. County Codes into the WR-300/301 Programming S.A.M.E. County Codes into the WR-300/301
A Single S.A.M.E. County Code:
• Press the “MENU” button to open menu options.
• Press the “UP” arrow to scroll through menu options until “County Code” is
displayed.
• Press the “SELECT” button and then the “UP” arrow to scroll through ”SINGLE”, “MUL-
TIPLE” or “ALL”.
• Display “SINGLE”, then press the “SELECT” button.
• “Code 01” will be displayed. Press the “SELECT” button to program this code. The first
digit space will start blinking.
• Use the “UP” arrow to scroll through the digits 0-9. Input the first digit then
press the “RIGHT” arrow to save that selection and move to the next digit.
• Continue programming all 6 digits in this way. When finished, press the “SELECT” button
and your entered code will be saved.
“ALL” S.A.M.E. County Codes is the Factory Setting:
Your WR-300/301 weather radio is preprogrammed to receive NWS weather and hazard alert
transmissions for all S.A.M.E. county codes within range. If this is what you want, leave the
radio set to “ALL”.
Multiple S.A.M.E. County Codes:
• Press the “MENU” button to open menu options.
• Press the “UP” arrow to scroll through menu options until “County Code” is
displayed.
• Press the “SELECT” button and then the “UP” arrow to scroll through “SINGLE”, “MUL-
TIPLE” or “ALL”.
• Display “MULTIPLE”, then press “SELECT”.
• Use the “UP” arrow to scroll through code locations 1-23. You are able to
program up to 23 different county codes into your WR-300/301 weather radio.
• Display the location you want then press the “SELECT” button. The first
digit space will start blinking.
• Use the “UP” arrow to scroll through the digits 0-9. Input the first digit then
press the “RIGHT” arrow to save that selection and move to the next digit.
• Continue programming all 6 digits in this way. When finished, press the “SELECT” button
and your entered code will be saved.
• To program your next code, press the “UP” arrow to go to the next code loca-
tion.
• When you have entered all your desired codes, press the “MENU” button to store your
settings.
Helpful Tip: The S.A.M.E. code is created using the following method:
• The first digit is the subcounty code-currently 0 in most areas.
• The second two digits represent the state code.
• The last three digits represent the county code.