Philips Magnavox 37MF437B - Manual (Page 19)

12
TV menu-Installation
Installation Language
Info
English
Français
Settings
Autoprogram
Source
Clock
Weak channel installation
Current software info
Reset AV settings
Español
Language
Television Installation
You can now start automatic installation. This
procedure can take more than half an hour.
Previous Start
Autoprogram
Info
Settings I Installation
Cable Start now
Antenna
Antenna
Notes:
• When you have locked TV channels before initiating Autoprogram, a message appears asking to enter your PIN code in
order to complete Autoprogramming.
• When channel update is interrupted, the new updated channel information is retained along with the old un-updated
channel information.
• Channel information about an ATSC channel is updated only for the ATSC channel currently tuned.
• If an NTSC channel is tuned, then in Background Autoprogramming the TV will scan all the possible ATSC frequencies
and update information.
• Weak channel installation allows you to manually tune weak ATSC channels in order to adjust the antenna and thus
optimize signal quality for that channel. (See Installation menu, Weak channel installation, p. 13.)
• Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
• If Antenna/cable signal is interrupted more than 30 minutes, TV will go into off mode. You are requested to press Power button
or CH + / - button to turn on the TV.
Select the menu language
Press the MENU button on the remote control.
Use the cursor down to select Installation in the Settings menu.
Use the cursor right to enter the Installation menu.
Select
Language and enter the list of available languages with the
cursor right.
Select your preferred language with the cursor up/down and press
the
OK button to confi rm your selection.
Proceed with the Installation menu.
Store TV channels
1
2
3
4
5
6
Select Autoprogram in the Installation menu.
Use the cursor right to enter the Autoprogram menu.
Select Cable or Antenna in the Installation mode.
When Antenna is selected, the TV will detect antenna
signals and will search for antenna TV (NTSC and ATSC) channels
available in your local area.
When
Cable is selected, the TV will detect cable company
supplied signals and will search for cable TV (NTSC, ATSC, QAM
modulated) channels available in your area.
Make sure that registration with your cable TV provider and
connection of equipment are completed.
Select
Start now with the cursor right key.
Press the OK button.
Press the green button “ Start” to start Autoprogramming. The
menu screen disappears and the progress of Autoprogramming
is displayed. The progress bar indicates the number of analog and
digital TV channels found.
Auto programming may take up to 20 minutes to complete. Digital
channels will take longer than Analog to fi nd and program. Please
wait until you see the Auto Programming complete message. The
TV will then switch automatically to the fi rst channel found.
Note: All channels must be unlocked in order to autoprogram. If
requested, enter your PIN code to unlock all channels. (p. 25)
1
2
3
4
5
6