Melissa 740-095 - Manual (Page 17)

FILTERS
The motor filter is a HEPA filter placed inside the dust compartment.
Open the dust compartment and gently pull the filter free of the holders. The filter
should be cleaned with the supplied brush and pin (This is placed in the drawer
at the bottom of the vacuum cleaner). The pin is being used for cleaning between
the grooves.
This filter may be washed in lukewarm water without use of any chemicals. None
of the filters can be washed in a washing machine or a dishwashers.
WHEN THE CONTAINER HAS BEEN EMPTIED AND IS PUT BACK INTO THE
VACUUM CLEANER AGAIN, YOU CAN HEAR IT SNAP BACK INTO
POSITION. ONLY THEN WILL IT BE READY FOR USE.
REPLACING THE MICROFILTER
The micro filter is the filter placed on the side of the vacuum cleaner:
Press the release-button on the air outlet grill and pull it out at the same time.
Remove the micro filter and insert a new filter.
Insert the exhaust grating back in place.
EXTRA FEATURES
The cleaner has two wheels at the rear and a multi-directional swivel wheel at the
front which enables it to move easily. It also has a convenient carrying handle.
Before storing your cleaner rewind the supply cord.
When the floor nozzle is in use, it may be necessary to adjust the suction pover
with the electronic suction power regulator. This is done at the top of the vacuum
cleaner and is useful when cleaning curtains, furniture, carpets or hard floors.
MAINTENANCE
Pull out the plug and if necessary clean the appliance on the outside with a damp
cloth.
Never immerse the appliance into water and other liquids!
17
VC-318_IM 28/11/03 10:15 Side 17