Muratec F-98 - Manual (Page 78)

Beyond the basics
4 The LCD now asks whether you want to enter a number:
If you want to enter or modify a number, press ENTER and proceed to step 5.
Otherwise, press PROGRAM and skip to step 10.
5 Depending on whether you have already entered at least one number into the
blocked numbers list, the display shows one of the following:
or
If you have not entered any numbers in the blocked numbers list, skip to step 7.
Otherwise, proceed to step 6.
6 If you want to modify an existing entry in the blocked numbers list, press
PROGRAM repeatedly until you see the number you want to modify.
… or …
If you want to enter a new number in an already-started blocked numbers
list, press
PROGRAM repeatedly until you find an empty position in the list (as
in the first display in step 5).
Note: To clear a number from the list, see “Clearing a number from the
blocked numbers list,” right column.
7 Use the numeric keypad to enter the last eight characters of a fax number you
want to block. For example, if you want to block a fax from someone with a
Subscriber
ID of 972-555-3038, you should enter 5, 5, 5, -, 3, 0, 3, 8:
To change only a specific digit of an entry, press to move leftward or
to move rightward until the cursor is under the digit, then use the numeric
keypad to enter the correct digit.
8 Press ENTER to save the setting. The display will show the next “slot” in the
blocked numbers list.
If you do not want to enter or change a number for this slot, proceed to step 9.
If you do want to enter or change a number for this slot, repeat steps 5–8.
9 Press STOP . The display now asks whether you want to print the list.
10 If you do want to print the list, press ENTER and your machine will print it.
If you don’t want to print it, press STOP and your machine will return to its
normal standby mode.
Clearing a number from the blocked numbers list
To clear a number from the list:
1 Press PROGRAM , J , 1, 1, ENTER .
If your Block Junk Fax setting is either Mode2 or Mode3, skip to step 3.
2 Press PROGRAM until you see your preference, Mode2 or Mode3.
3 Press ENTER , ENTER . The display shows:
If this is the number you want to clear, skip to step 5.
Otherwise, proceed to step 4.
4 Press PROGRAM repeatedly until you see the number you want to clear.
5 Press CANCEL to clear the number.
To clear another number from the blocked numbers list, repeat steps 4–5.
Otherwise, proceed to step 6.
6 Press STOP . The display now asks whether you want to print the blocked
numbers list.
If you do want to print the list, press ENTER and your machine will print it.
Otherwise, press STOP to return your machine to its normal standby mode.
Print BlockJunk Dial
Enter/Stop
Select BlockJunk No.
01:555-2971
Block Junk Fax:Mode2
Program/Enter
Block Junk Fax:Off
Program/Enter
Print BlockJunk Dial
Enter/Stop
Enter Fax Number
01:555-3038
Select BlockJunk No.
01:555-2971 Enter Fax Number
01:_
Set BlockJunk Dial
Program/Enter
2.50