Metrologic Instruments TECH 7 - Manual (Page 8)

Stand Installation
With the Metrologic stand (Part #45475), the scanner can be posi-
tioned in one of two directions. The two orientation choices are vertical
or horizontal. (Refer to Figure 1)
To install this stand, use the four 6-32 x ½ inch machine screws and
two #10 pan head wood screws.
1. Drill two holes into the work
surface that are the same size
and distance as the holes on
the stand base. (Refer to
Figure 2)
2. Use the two #10 pan head
wood screws to attach the
stand to the work surface.
3. To fasten the scanner:
z For a horizontal mount,
align the four holes on the
back of the scanner with
the four clearance holes
located on the stand
marked with an X in Figure 3.
z For a vertical mount,
align the four holes on
the back of the scanner
with the four clearance
holes located on the stand
marked with a Y in Figure 3.
4. Fasten the scanner to the stand by inserting the four 6-32 x ½
inch screws into the four holes in the scanner's case.
4
Horizontal Mount Vertical Mount
Figure 1: Stand Orientation
3.00 in
1.00 in
1.50 in
Figure 2: Base of Stand
Figure 3: Back View of Stand
X = Holes for Horizontal Mount
Y = Holes for Vertical Mount
Y
X X
Y
Y X X Y