MicroNet Technology IP TELEPHONY GATEWAY SP5052 User Manual
Page 49
49
1.3 System
Config
z
Keypad Type: Select different DTMF Keypad Type (For Advanced User)
z
Dial Plan: Set DTMF digit limitation (0 is for any digits)
z
Inter Digit Time: Set the DTMF inter digit time (second)
z
End
of
Dial:
Digit type of end of dialing. ( 0:No end of dialing, 1:[*] button, 2:[#] button )
z
2nddial: This command is necessary for setting one time dial method use.
While user would like to skip 2nddial process, VoIP SP5054 must close
2nddial and set as 0 (2nddial off). The default value is set as 1 (2nddial
on).
z
Call Alive: Enable the function to check connection (Both side must
support)
z
Line
Seizure:
Choose line seizure mode (None/UCD)
z
Gateway Service: Specify gateway service type. (0: Dial in service,1:
Direct in line service, 2: HotLine/LineToLine service.)