Morphy Richards 47076 - Manual (Page 7)

77 UUKK HHeellpplliinnee 00887700 006600 22661100 RReeppllaacceem meenntt PPaarrttss 00887700 115577 66664411 IIrreellaanndd HHeellpplliinnee 11880000 440099111199
Locating the filter
1 To remove the filter holder, lift by
using the two handles either
side. To clean, see ‘Cleaning and
Maintenance’ section on page 7.
2 To refit, place the removable
filter holder into the top of your
coffee maker. Ensure that the
cut out on the filter holder lines
up with the slot at the back of
the product.
3 Then place the permanent mesh
filter inside the filter holder.
Note: Ensure the filter holder is
correctly located, otherwise the
non-drip valve will not open,
causing the filter to flood.
CLEANING AND
MAINTENANCE
Descaling
• If you live in a hard water area,
we recommend that your coffee
maker is descaled at regular
intervals, e.g. every 2-3 months.
In areas of moderately hard
water, you should descale every
6 months.
• If the water filters through more
slowly than usual, it is a sign
that descaling is necessary.
• We recommend you use a
proprietary liquid descaler which
is especially made for coffee
makers and plastic kettles.
Follow the instructions on the
bottle or sachet, and then
operate the coffee maker with
just water 3 times before making
coffee.
• Do not use a kettle descaler
unless the packet specifically
states it is suitable for coffee
makers.
Note: The permanent mesh filter
should not be used during
descaling.
Cleaning care
• Unplug the coffee maker and
allow to cool.
• Do not immerse the coffee
maker in liquid.
• Rinse the water reservoir
occasionally with cold water. Do
not use a cloth as any residue or
lint may be left behind to clog
the coffee maker.
• Remove the permanent filter,
discard any used coffee and
wash. Extended soaking helps
to remove coffee stains from the
mesh.
• Wash the glass jug, jug lid, and
filter holder in warm soapy
water. Rinse and dry all parts
thoroughly. Refit the filter and
filter holder.
• Wipe all external surfaces,
including the warming plate,
with a damp cloth and dry
thoroughly.
• Care must be taken to ensure
that the non-drip valve situated
on the bottom of the filter holder
is not damaged during cleaning.
• Never use harsh or abrasive
cleaners.
• NO parts are suitable for
cleaning in a dishwasher.
Helpline
If you have any difficulty with
your appliance, do not hesitate
to call. We are more likely to be
able to help than the store from
where you bought it.
Please have the following
information ready to enable our
staff to deal with your enquiry
quickly:
• Name of the product.
• Model number as shown on the
underside of the appliance.
• Serial number as shown on
underside of the appliance.
UK Helpline 0844 871 0946
Replacement Parts 0844 873 0712
Ireland Helpline 1800 409 119
77
47076 Rev2 18/6/08 13:58 Page 7