Magic Chef MCWC44DZ - Manual (Page 8)

Temperature setting
• Unlock the control panel by pressing the pad for approximately 3 seconds. Once the control
panel is unlocked an audible beep will be heard and the indicator will go out.
• Under normal conditions the temperature display indicates the current temperature of the
corresponding zone. When adjusting the temperature, the temperature display will flash to
indicate that the temperature is being adjusted.
• The temperature in both upper zone and lower zone can be set independently by pressing
(warmer) or (colder) pads that correspond to desired zone. The temperature range of
both zones can be set between 39°F to 61°F (4° to 16°) +/- 5°F.
• When the pad (warmer) or (colder) is pressed, the temperature displayed will increase
or decrease in an increment of one degree. If the pad (warmer) or (colder) is pressed
and held for 2 seconds, the temperature displayed will increase or decrease in a speed of one
degree per half second.
• Once you have adjusted the upper or lower zone to the desired temperature, release the
temperature pad. At this time the temperature displayed will flash for approximately 3 seconds
to confirm the selected temperature. Once the display stops flashing the temperature display
will indicate the current temperature of that zone.
Note:
The temperature display can be changed between Celsius and Fahrenheit by simultaneously
pressing and holding both pads
(warmer) and (colder) for the upper zone for
approximately 3 seconds. This unit cannot be in (Lock) mode to perform this operation.
Interior Light
To turn on / off the interior light, press the
( Light) pad. The unit cannot be in the (Lock) mode to
perform this operation. Note: The light will turn on / off after the touch pad is released.
AUTOMATIC DEFROST
There is no need for manual defrosting of this appliance due to automatic defrosting function.
• The ice build-up on the inner back wall during compressor operation will be automatically
defrosted in a compressor off cycle.
• When defrosting is in process, the indicators for both zones will go off, and the circulation fans
for both zones will run.
•
Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan
located above the compressor, from where it evaporates.
EN 7