beautypg.com

Setting up your snow thrower, Warning – MTD 769-04095 User Manual

Page 7

background image

7

3

Figure 3-5

Prior to operating
your snow thrower,
refer to Auger Control
on page 9. Read and
follow all instructions
carefully and perform
all adjustments to
verify your unit is
operating safely and
properly.

Setting Up

Your Snow

Thrower

WARNING

Slide

chute assembly over chute opening, making

sure the flange keepers are beneath lip of chute
adapter. The notches should engage with the spiral
end of the chute crank. See Figure 3-5.

• Secure flange keeper, locknuts and screws previously

removed. Tighten all flange keepers and hardware
with two 7/16” wrenches. Do not over tighten.

NOTE: If necessary the chute crank support bracket can
be adjusted so the spiral on the chute crank fully engages
the teeth on the chute assembly. Refer to the Adjustment
Section.
• If not already attached, slip the cables that run from

the handle panel to the discharge chute into the cable
guide located on top of the engine. See Figure 3-6.

• Wrap the wire from the head lamp down the right

handle until the wire can be plugged into the alternator
lead wire under the fuel tank. See Figure 3-7.

Figure 3-6

Figure 3-4

Alternator Lead

Lamp Wire

Alternator
Lead

NOTE:

Wheels are omitted from illustration for clarity.

Figure 3-7