Motorola SYMBOL DS9808 - Manual (Page 2)

DS6708 Poster
BLACK
PANTONE 285
http://www.motorola.com/ds9808
Perforation Perforation
SYMBOL DS9808
SYMBOL DS9808
Motorola, Inc.
One Motorola Plaza Holtsville, New York 11742-1300, USA
DS6708 Poster
SYMBOL DS9808
Caution
class 2 laser light
when open.
Do not stare
into beam.
Attentionlumiére
laser en cas d'ouverture.
Ne pas regarder dans
le faisceau.
Vorsicht
laserlicht klasse 2,
wenn abdeckung geöffnet.
Nicht in den strahl blicken.
LASER LIGHT- DO NOT STARE INTO BEAM . CLASS 2 LASER PRODUCT. LASERLICHT - NICHT IN DEN STRAHL BLICKEN. LASER KLASSE 2. LUMIÈRE LASER - NE PAS REGARDER DANS LE FAISCEAU. APPAREIL À LASER DE CLASSE 2 630-680nm, 1mW
PN:DS9808-XXXXXX MADE IN XXXXXX XXXXXXXXXXXXXXX
(S)S/N: XXXXXXXXXXXX SN BAR CODE
XXXX
MFD:XXXXXXX X
MODEL:DS9808 5V 850mA 5V 1.5A with optional module
MOTOROLA INC., N.Y. 11742
50
0 1 2 3 4 5
0 1 2 3 4 5 0 1 2 3 4 5
DS9808-LR
DS9808-SR
DS9808-LR
DS9808-SR
OPTIMUM ARM POSITION AVOID EXTREME WRIST ANGLES
Low/medium/high beep
Power up
Short medium beep
Bar code decoded
4 long low beeps
Transmission error
detected; data is
ignored
Standard Use Hand-Held Scanning
High/low beep
Correct programming
sequence performed
Low/high beep
Incorrect
programming
sequence or
“Cancel” bar code
scanned
High/low/high/low beep
Successful
parameter
setting
Parameter Menu Scanning
BEEPER INDICATIONS LED INDICATIONS
Off
Scanner is on
and ready to scan,
or no power to
scanner
Green
Bar code is
successfully
decoded
Red
Transmission
error
Hands-Free (Presentation) Scanning
Off
No power to
scanner
Off Momentarily
Bar code is
successfully
decoded
Green
Scanner is ready
to scan
Red
Transmission Error
Local Contact:
OPTIMUM SCANNING
AVOID BENDING AND REACHING
REGULATORY INFORMATION
Ergonomic Recommendations
Caution: In order to avoid or minimize the potential risk of ergonomic injury follow
the recommendations below. Consult with your local Health & Safety Manager to
ensure that you are adhering to your company's safety programs to prevent
employee injury.
• Reduce or eliminate repetitive motion
• Maintain a natural position
• Reduce or eliminate excessive force
• Keep objects that are used frequently within easy reach
• Perform tasks at correct heights
• Reduce or eliminate vibration
• Reduce or eliminate direct pressure
• Provide adjustable workstations
• Provide adequate clearance
• Provide a suitable working environment
• Improve work procedures.
Regulatory Information
This device is approved under the Symbol Technologies brand: Symbol
Technologies, Inc., is the Enterprise Mobility business of Motorola, Inc.
(“Motorola”).
This guide applies to Model Number DS9808
All Motorola/Symbol devices are designed to be compliant with rules and
regulations in locations they are sold and will be labeled as required.
Local language translations are available at the following website:
http://www.motorola.com/enterprisemobility/support.
Any changes or modifications to Motorola/Symbol Technologies equipment, not
expressly approved by Motorola/Symbol Technologies, could void the user’s
authority to operate the equipment.
Laser Devices
The laser classification is marked on one of the labels on the device.
Class 1 Laser devices are not considered to be hazardous when used for their
intended purpose. The following statement is required to comply with US and
international regulations:
Caution: Use of controls, adjustments or performance of procedures other than
those specified herein may result in hazardous laser light exposure.
Class 2 laser scanners use a low power, visible light diode. As with any very bright
light source, such as the sun, the user should avoid staring directly into the light
beam. Momentary exposure to a Class 2 laser is not known to be harmful.
Power Supply
Use ONLY a LISTED Motorola, Type no. 50-14000, or PWRS-14000, Direct Plug-In
power supply, marked Class 2 or LPS, or SELV, Rated 5 Vdc, 850 m A Min.
(IEC 60950-1). Use of alternative power supply will invalidate any approvals given
to this device and may be dangerous.
AVOID REACHING
AVOID BENDING
Recommended Usage Guide
AVOID EXTREME
WRIST ANGLES
72-109917-01 Revision B April 2010
Alternate left and right hands
taking breaks and task rotation
recommended
Alternate left and right hands
taking breaks and task rotation
recommended
MOTOROLA and the Stylized M Logo and Symbol and the Symbol logo are registered
in the U.S. Patent and Trademark Office. All other product or service names are the
property of their respective owners.
© Motorola, Inc. 2010
© MOTOROLA, INC. 2010 All rights reserved.
Motorola reserves the right to make changes to any product to improve reliability, function, or design.
Motorola does not assume any product liability arising out of, or in connection with, the application or
use of any product, circuit, or application described herein. No license is granted, either expressly or by
implication, estoppel, or otherwise under any patent right or patent, covering or relating to any
combination, system, apparatus, machine, material, method, or process in which Motorola products
might be used. An implied license exists only for equipment, circuits, and subsystems contained in
Motorola products. MOTOROLA, the Stylized M Logo and Symbol and the Symbol logo are registered
trademarks of Motorola, Inc. Other product names mentioned in this manual may be trademarks or
registered trademarks of their respective companies and are hereby acknowledged.
This Motorola Product may include Motorola Software, Commercial Third Party Software, and Publicly
Available software. Refer to Product Reference Guide for complete copyright, conditions and disclaimer
information.
Warranty
For the complete Motorola hardware product warranty statement, go to:
http://www.motorola.com/enterprisemobility/warranty.
Service Information
If you have a problem using the equipment, contact your facility’s Technical or Systems Support. If there
is a problem with the equipment, they will contact the Motorola Enterprise Mobility Support at:
http://www.motorola.com/enterprisemobility/contactsupport.
For the latest version of this guide go to: http://www.motorola.com/enterprisemobility/manuals.
Waste Electrical and Electronic Equipment (WEEE)
Tested to comply
with FCC Standards
FOR HOME OR OFFICE USE
Radio Frequency Interference Requirements
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
Radio Frequency Interference Requirements – Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Marking and European Economic Area (EEA)
Statement of Compliance
Motorola/Symbol hereby declares that this device is in compliance
with all the applicable Directives, 2004/108/EC and 2006/95/EC.
A Declaration of Conformity may be obtained from
http://www.motorola.com/enterprisemobility/doc
Japan (VCCI) - Voluntary Control Council for Interference
Class B ITE
B
This is a Class B product based on the standard of the Voluntary Control Council
for Interference from Information Technology Equipment (VCCI). If this is used
near a radio or television receiver in a domestic environment, it may cause radio
interference. Install and use the equipment according to the instruction manual.
Korea Warning Statement for Class B ITE
Class User’s Guide
B class As this equipment has obtained EMC registration for household
use, it can be used in any area including residential areas.
Hands-Free Scanning
Türkçe: AB Müşterileri için: Kullanım süresi dolan tüm ürünler geri dönüştürme için Motorola'ya
iade edilmelidir. Ürünlerin nasıl iade edileceği hakkında bilgi için lütfen şu adresi ziyaret edin:
Symbol products using lasers comply with US 21CFR1040.10 and
1040.11 except for deviations pursuant to laser notice no. 50,
dated June 24, 2007 and IEC 60825-1 (Ed. 2.0), EN60825-1:2007.
123SCAN 2
123Scan2 is an easy-to-use, PC-based software tool that enables rapid and easy customized setup via a bar code or USB
cable. For more information, visit: http://www.motorola.com/123Scan2.
Aiming Hand-Held Scanning