Philips Magnavox 26MF605W - Manual (Page 36)

36
T
ROUBLE
S
HOOTING
T
IPS
No Power
• Check the TV power cord. Disconnect the power cord from the power outlet for 10 seconds,
then reinsert the plug into the outlet. Press POWER to turn on the TV again.
• Make sure the outlet is not on a wall switch.
• Make sure a fuse has not blown at the power outlet.
No Picture
• Check the antenna or Cable TV connections. Connect the antenna or Cable TV signal securely to the TV’s
75Ω jack on the rear of the TV.
• Set TUNER MODE correctly. Details are on page 18.
• Activate AUTO PROGRAM to find all available channels. Details are on page 19.
• In case you hear only sound and don’t see any picture in S-Video or Video (CVBS) mode. Please check if you
have connected Video signal to S-Video or Video (CVBS) input. Only one of the two video inputs can be
connected to sound. This means that the same sound can be heared in S-Video and Video (CVBS) mode.
No Sound
• Press the VOL+ and VOL- buttons to adjust the volume.
• Press the MUTE button on the remote control to cancel or restore the volume.
• If you have connected other equipment to the TV (such as a VCR or DVD Player), make sure the audio cables
are connected securely between the TV and the other equipment.
• Check the SOUND settings. Details are on page 22 or 24.
• In case you hear wrong sound in S-Video or Video (CVBS) mode. Please check if you have connected the right
sound signal to AV in (S-Video or Video input). Only one of the two video inputs can be connected to sound,
but both video signals can be connected. This means that only one of the two sound inputs can be heared in
S-Video and Video (CVBS) mode.
Remote Control does not work.
• Check the batteries. If necessary, replace them with two AAA heavy duty (zinc chloride) or alkaline batteries.
• Clean the remote control as well as the remote control sensor on the front of the TV.
• Check the TV power cord. Disconnect the power cord from the power outlet for 10 seconds, then reinsert
the plug into the outlet. Press POWER to turn on the TV again.
• Make sure the outlet is not on a wall switch.
• Make sure a fuse has not blown at the power outlet.
• Always point the remote control toward the front of the TV (toward the remote sensor).
• Make sure that you use the supplied Magnavox Remote control, only the supplied Magnavox Remote control
can be used with this LCD-TV set.
TV displays wrong channel or no channels.
• Repeat channel selection.
• Add the channel number(s) into the TV’s memory. Use STORE. Details are on page 20.
• Make sure TUNER MODE is set correctly. Details are on page 18.
Then activate AUTO PROGRAM to set up all available channels. Details are on page 19.
Poor Sound
• Check if AVL (audio settings menu) is switched on [yes].
• Select personal smart sound mode and optimize in the Audio onscreen menu the treble and bass settings.
• Make sure that your external device, for instance VCR, DVD or other AV device has a good quality sound output.
Noisy Picture
• Select the Weak signal Smart Picture Mode, in this mode noise from bad quality video signals will be suppressed.