Midland Radio XTC Wearable Video Camera XTC300 - Manual (Page 5)

4 www.midxtc.com
Camera Mounting and Aiming
Mount on Dual Track System
The XTC-300 was innovatively designed with an identical dual track
mount system on either side of the camera. This allows you to mount it
on both sides of a helmet with ease. In addition, the main mount piece is
interchangeable and can be moved from the helmet mount to the goggle
mount. This eliminates the hassle of having to remount the camera
every time.
To mount the camera on the main mount piece, slide the camera onto
the dual track system with the two notches on the mount facing towards
the back of the camera.
To detach the camera from the main mount, hold the camera with the
lens facing away from you. Press down the mount release switch and pull
the mount towards yourself.
Aiming the Camera when mounted with the dual track mount:
When mounting the camera on a helmet, you must do the following:
1. Consider what you would like to shoot and mount the camera
accordingly- left side, right side or top.
2. Find a flat surface and ensure the area is clean of dirt and debris.
Remove the cover of the adhesive pad and adhere to the helmet.
3. Once attached, adjust the camera to be sure you are not filming the
sky or the ground.
Mount using the Thread Mount
On the bottom of the XTC-300 is a standard thread mount that al-
lows the camera to be mounted to a tripod or other fixture with a 1/4-20
(1/4” diameter, 20 threads per inch) 5/16 deep thread. The vented
helmet strap mount is a screw type mount. To affix the camera, insert
the screw on the mount into the camera thread and rotate the camera
clockwise to tighten down onto the screw.
Thread Mount
Screw Mount
Aiming the Camera when mounted with the thread mount:
When mounting the camera on the handlebars of a bike or with the
vented helmet strap mount follow these steps:
1. Consider what you would like to shoot and mount accordingly.
2. Ensure once attached that the camera is aimed straight and not
towards the ground or at the sky.
Reformatting the Micro SD card
The micro SD card can be reformatted while in the camera. This allows
you to delete all the videos at one time. Follow these steps:
1. Press and hold the micro SD reformat button.
2. Move the RECORD switch to the on position
3. Keep the micro SD card reformat button down until the SD card indicator
begins blinking green.
4. Formatting is complete when the SD card indicator turns on solid.
5. Move the RECORD switch to the off position.
Camera Mounting and Aiming
Dual Track
Mounting System
Mount Release
Switch
Interchangeable
Mount
Over tightening may cause damage
to the mount and/or camera
Note: The camera cannot reformat the micro SD card if the low
battery light is on.
Ensure battery is fully charged before formatting