Miele KM5656 - Manual (Page 36)

Cut out
^ Make the countertop cut-out following
the dimensions given in the
illustration.
Remember to maintain a minimum
distance of 2" (50 mm) between the
rear wall and the right or left side.
See also "IMPORTANT SAFETY
INSTRUCTIONS".
^ Seal the cut surfaces with a suitable
sealant to avoid swelling caused by
moisture.
The materials used must be heat
resistant.
If during installation the seal around
the frame does not sit flush with the
countertop in the corners, the corner
radius, maximum
3 /
16
" (4 mm), can
be carefully filed down to fit.
Installation
36