Qmvm series, Recommended operating conditions – Master Bilt QMVM-72 User Manual
Page 2

908 Highway 15 North • New Albany, MS 38652
PHONE: 800-647-1284 or 662-534-9061 • FAX: 800-232-3966 or 662-534-6049 • www.master-bilt.com
QMVM SERIES
QUANTUM SERIES MEDIUM TEMP VERTICAL
OPEN DISPLAY MERCHANDISERS
TECHNICAL SPECIFICATIONS
LISTINGS
HOOKUP
BID SPECIFICATIONS
Item no. QMVM-_______________
Provide_________( ) Quantum Series
Medium Temp Vertical Open Display
Merchandiser(s), Master-Bilt model no.
QMVM-__________.
Merchandiser to be constructed of 24
gauge painted textured galvanized steel
interior and exterior and will be equipped
with an electronically controlled monitor-
324-3/11-web
©Master-Bilt Products division of Standex International, Inc. All rights reserved. Printed in U.S.A.
Electrical: QMVM-36E and QMVM-48E via plug in, 9 foot long
flexible four wire 208-230v 14/4 cord with neutral and ground
wires and molded plug. QMVM-72E is a hardwire.
Plumbing: Requires connection to customer’s drain
PLAN VIEW
ELEVATION VIEW
ing system.
Other features include adjustable two-
position shelves, independent shelf light-
ing, perforated interior back wall, electric
defrost and 2" foamed-in-place “zero ODP”
urethane insulation.
The refrigeration system to be self-con-
tained, have a front condenser air intake
and rear air discharge and use R-404A refrig-
erant. The temperature range will be 34° to
41°F (1° to 5°C).
Merchandiser to have standard limited
three year extended compressor warranty
and two year limited parts and labor war-
ranty.
Merchandiser to be UL and C-UL listed
and UL EPH classified.
MODEL
DIMENSIONS
(in.)
DIMENSIONS
(mm)
VOLTS
AMPS*
UNIT
H.P.
NO. OF
SHELVES
STANDARD
SHELF
WIDTH
(in inches)
CAP.
CU.
FT.
SHIP
CU.
FT.
SHIP
WT.
LB/KG
L
D
H
L
D
H
QMVM-36E
36
30
81
914
762 2057
208-230
13.5
1
3
14 x 31
1
/
8
13.6
89.0
525/239
QMVM-48E
48
30
81
1219 762 2057
208-230
16.1
1
3
14 x 43
1
/
8
20.4
107.0
640/291
QMVM-72E
72
30
81
1829 762 2057 115/208-230 3.7/13.7
1
1
/
2
6
14 x 33
1
/
16
31.5
152.0
860/391
*If condensate evaporator pan accessory is used,
it must be field installed and requires a dedicated
15 amp, 120 volt circuit.
Note: 208-230/60/1 also requires neutral
and safety ground wire.
SIDE VIEW
RECOMMENDED OPERATING CONDITIONS
All specifications subject to change without notice.
• Merchandisers designed to hold product
in the 34° to 41°F (1° to 5°C) range
• Designed to operate in air-conditioned
stores where the maximum temperature is
75°F and the maximum relative humidity
is 55%
• Should not be installed in direct sunlight
• Should not be installed near HVAC vents,
fans or doorways that will disrupt airflow
and compromise the function of the air
screen inside the case
• Bottom shelf should not be loaded such
that the front air intake is obstructed
• Floor drain should be properly trapped
• Factory installed controls should not be
altered, removed or replaced without
consent of the factory
• Product must not be displayed in the cold
air curtain
NEMA L14-20P
(QMVM-36E & QMVM-48E)