Maxon Telecom SP-200K Series - Manual (Page 14)

XIV. Scan Modes
Scanning is a Dealer programmable feature that allows you to monitor a
number of channels or channels within a Group. Your radio communications
Dealer will help you define a scanning mode and your channel "scan list" .
Normal Channel Scan
Once the scan list has been established, initiate scan by pressing and
releasing the scan button (first button below the P-T-T bar).
If a conversation is detected on any of the channels in the scan list, the radio
will stop on that channel and you will be able to hear the conversation. If
programmed for normal scan TX, you will be able to transmit on that active
10
STATUS DESCRIPTION LED COLOR LCD INDICATION AUDIBLE TONE
Normal Power On - Ready N/A 188 Melody
Call Received Orange Channel Number N/A
Correct Call Green Channel Number N/A
Busy Channel Orange Channel Number N/A
Valid Selcall Decode Green Flashing Channel Number One to Three Tone
Alert
Radio Stunned N/A Channel Number Two Beeps
Radio Received N/A Channel Number Melody
Transmit Red Channel Number N/A
Transmit Not Allowed Red Flashing Alternating UL/ Two Beeps Repeated
Channel Number
Keypad Lock N/A LO Two Beeps Repeated
Scanning Normal Scan Mode Green Flashing Group Number N/A
Priority Scan Mode Green Flashing N/A N/A
Priority Look Back Green Flashing Lb / Channel N/A
Scan Mode number
Scan Edit Edit Scan List Red Single Flash SE N/A
Priority Edit Priority Channel Red Two Flashes PE N/A
Edit
Warning
Low Battery Red Flashing LC 3 Beeps Repeated
Busy Channel Lockout Orange bL Single Beep Repeated
TX Inhibit N/A _h/rO Two Beeps
Time-Out-Timer N/A Pt Single Beep/3 Beeps
Repeated
Error EEPROM N/A Er Single Beep Repeated
Unlock N/A UL Two Beeps Repeated
NOTE: All audible tones can be programmed "off" for silent operation.
XIII. Status Indicators and Audible Alert Tones, continued