Miller Electric S-32SL - Manual (Page 14)

OM-1546 Page 10
2-2. Installing And Aligning Wire Guide And Drive Roll
3/16 in
Ref. ST-091 547-D / Ref. ST-112 370-C / S-0856
When changing wire size or type,
check drive roll and wire guide size
(see Parts List).
Installing Wire Guide And Drive
Rolls:
1 Drive Roll Nut
2 Drive Roll Carrier
Turn nut one click until lobes of nut
line up with lobes of drive roll carrier.
3 Drive Roll
Slide drive roll onto drive roll carrier.
Turn nut one click.
Repeat procedure for top drive roll.
4 Inlet Wire Guide Screw
5 Inlet Wire Guide
Loosen screw. Install inlet guide so
screw is centered in groove in
guide, or so tip is as close to drive
rolls as possible without touching.
Tighten screw.
Aligning Wire Guide And Drive
Rolls:
6 Adjustment Screw
Only top drive roll alignment is ad-
justable. Turn adjustment screw in
or out until groove in drive roll lines
up with wire guide as shown.
Cleaning Drive Rolls:
Remove drive rolls, and clean
grooves using a wire brush.
Tools Needed:
3/8 in
3
5
6
5
4
2
1
3