Mazda CX-7 User Manual

Page 9

S E A T S

Always check the Owner’s Manual for more operating information and safety features

Shoulder belt
height
adjustment
To raise:
Push adjuster up.
To lower:
Pull button (1), slide
down; release button.

WARNING: Make sure
adjuster locks in one of
its positions.

Manual controls

1. Fore-aft adjustment

Lift lever and hold, slide seat,
release lever.

2. Raise/lower seat

(Driver’s seat only)
Pull/push lever and release.

3. Seat back angle

To adjust: Lift and hold lever,
lean forward or backward
to tilt seat, release lever.

4. Head restraint

To raise/lower: Pull up/hold
release button (8) and
push down.

Power driver’s seat*

5. Raise/lower front of seat

Pull/push front of switch vertically.
Fore/aft adjustment
Slide switch horizontally.
Raise/lower rear of seat
Pull/push rear of switch vertically.
Raise/lower seat
Pull/push center of switch
vertically.

6. Seatback angle

Press front/rear of switch
to change angle.

7. Lumbar support

adjustment*
Pull lever forward repeatedly
for more support.

Seats

WARNINGS: Do not adjust
seats while driving.
Seat belts must always be
worn when vehicle is in motion.
Air bags are supplemental
and do not replace seat
belt usage.
Always wear your seat belt
and properly secure children
12 and under in the rear seat.
Even with a deactivation
system, never place rear-facing
infant-safety seat in front
of any air bag, an infant is
in serious danger of being
injured or killed.
If you must install a forward-
facing child-safety seat in
the front seating position,
move vehicle seat as far
back as possible.

Seat belt emergency
locking mode

Belts lock only on hard acceleration,
braking, cornering or impacts of
about 5 mph or more.

Automatic locking mode
(all seat belts except
driver’s seat belt)

Must be used when installing
child-safety seat.
To activate: Pull webbing fully
out of retractor, allow belt to
retract until click is heard;
belt will only tighten.
To disengage: Unbuckle belt and
allow webbing to retract fully.

Child-safety seat

To install in rear outboard seats:
Use dual locking mode retractor
seat belts; see Owner’s Manual
for proper installation and child
seat tether and LATCH system
instructions.

WARNING: Use age
appropriate child restraints,
see Owner’s Manual and
state or province laws.

*Denotes optional equipment