Nesco JB-50 - Manual (Page 7)

4
E
n
g
lis
h
ASSEMBLY AND USE - BLENDER
• Place Motor Base on a flat, stable, anti-slip surface.
• Place the Blender Base onto center drive of the Motor Base and press firmly
until it locks into position.
• Lift both Retaining Brackets up and hook into slots provided in the
Blender Base. Press lower part of bracket to snap into locking position.
If brackets are not locked into position the product will not function.
• Place the ingredients into the Blender Base.
• Fit the Lid and Fill Cup. Do Not use the Fill cup when blending HOT liquids.
• Be sure On/Off switch is “O” - OFF position before plugging into 120
volt outlet.
• Set desired speed setting (P = pulse, 1 = low, 2 = high).
• When blending ice, pulse setting is recommended.
WARNING: Do not operate the appliance when dry or fill the jar with
hot liquids. Do not rinse the Glass Jar with hot water after preparing
cold food.
• Never open the Lid during operation.
CLEANING INSTRUCTIONS - BLENDER
Always unplug unit from outlet before cleaning.
Motor Base:
• Wipe with damp cloth, then dry. WARNING: Do not immerse Base in water or other
liquids. This may cause electrical shock or damage the appliance. Do not use abrasive
cleansers.
Blender Base:
• Before dismantling, half fill the base with warm water. Fit the lid and fill cup. Pulse switch
several times, repeat until water becomes clear.
• Wash in warm soapy water, rinse and dry. Handle carefully, Blender base is made of glass
and Blades are sharp!
All other parts:
• Wash in warm soapy water, rinse and dry. Do not use abrasive cleansers.