beautypg.com

Maintenance – Murray 11053x92a User Manual

Page 16

background image

MAINTENANCE

16

F-051302L

LUBRICATION

Every 25 hours and/or at the beginning of

each season, make sure the gear box is

filled with lubricant (see Figure 9). Tubes of

gear lubricant are available from most auto-

motive supply stores. Use portable tool

grease such as Lubriplate 630AA (Product

No. 06787, 1-3/4 oz. tube) or Lubriplate

GR-132 (Product No. 15892, 10 oz. tube).

After cleaning and before storage, apply oil

to the tine shaft (see Figure 9).

WARNING: Allow the transmis-

sion to cool before filling with

grease.

1. Remove both left side tines. See “How

To Replace The Tines” in the Service

and Adjustments section.

2. Remove the air vent screw (see

Figure 9).

3. Mount a grease gun onto the grease fit-

ting. Fill the transmission until the

grease begins to come out of the air vent

screw hole.

4. Reinstall the air vent screw.
5. Check the condition of the felt washer

(see Figure 9). Replace the felt washer

if it is damaged (see the Repair Parts

section in this manual).

6. Clean and lubricate the tine shaft with a

few drops of oil.

7. Reinstall the left side tines.
8. Remove the right side tines. Check the

felt washer for damage. Clean and oil

the tine shaft. Reinstall the right side

tines.

Figure 9

Grease Fitting

Tine

Shaft

Air Vent Screw

Felt

Washer

HOW TO CLEAN THE TINES

Always remove dirt and debris from the culti-

vator after each use. Remove any string,

wire or vegetation that may become lodged

in the mechanism and stop the tines from

rotating.
1. Release the throttle control and move

the on-off switch to the OFF position.

Disconnect the spark plug wire from the

spark plug.

2. While wearing gloves, remove the hair-

pins and clevis pins that secure the tine

assemblies to the shaft (see Figure 10).

Remove the tines from the shaft.

3. Remove any lodged debris from the

shaft and tines. Clean and lubricate the

tine shaft with a few drops of oil.

4. Reassemble the tines on the shaft and

secure with a clevis pin and hairpin.

5. Connect the spark plug wire to the spark

plug.

Figure 10

Clevis

Pins

Hair Pins

Tines