beautypg.com

Installation, Installing the unit – Magnadyne M6100CD User Manual

Page 12

background image

12

Installation

Remove Transportation Screws

Before installing the unit, remove the two

screws shown in the illustration below.

Note: If this unit is to be installed in a boat or a

spa, you should use the two pieces of plastic

film (30 mm X 20 mm) supplied to seal the two

holes after removing the screws.

Installing the Unit

1. Using the mounting paper template supplied

with the unit, determine the mounting location

and then stick the template on the location.

2. Cut and remove the hatching area on the tem-

plate. Then drill four 1/8" mounting holes in the

exact position according to the mounting paper.

3. Use the glue paper to stick the two mounting

brackets to the back of the mounting surface.

The screw holes of the brackets must respec-

tively aim at the mounting holes in order to fix

the unit to the mounting surface.

4. Open the two pieces of rubber cover on the unit

to display the four screw holes then using four

screws (M4X30) to mount the unit to the dash-

board.

Remove screws

before installation

Mounting Surface

Template

Mounting

Holes

Mounting

Location

Mounting Surface

Mounting

Brackets

Mounting

Surface

Rubber Cover

Screws

Mounting Surface

Rubber

Cover