Monitor Audio RS W12 - Manual (Page 6)

6
© Monitor Audio 2005 RS W12 Rev 1
Spiked Foot Fixing For Carpeted Floors
The amazingly engineered composite Silver RS series foot encorporates a spike
for use on carpeted floors and also, a soft polymer pad (for use on wooden or
tiled floors).
Please ensure there are no
hidden wires under the carpet, or
trailing mains leads that could be
damaged by the spikes.
The foot comes fully assembled for use on
carpeted floors. All that is required is fixing
into the plinth. This is achieved by simply
screwing the feet fully into the 4-threaded
insert in the underside of the cabinet. If your
carpet has a very thick pile, remove the soft
polymer pad from the foot to ensure the
spike goes right through the carpet into the
floor. With great care turn your cabinet the
right way up.
Place the cabinet in your
desired location, and check that it is level on
all sides. If it is slightly off level, unscrew the
spike at the lowest point and check again.
Continue this process until the cabinet is
fully level. Use the locking nut on the foot to
fix the foot in place and to stop any unwanted
vibrations.
Spiked Foot Fixing For Wooden/Hard Floors
For use on solid floors or where spikes
are inappropriate, it is possible to use the
foot without the spike insert. To use the
foot in this manner carefully grip the
knurled portion of the spike and rotate
anti clockwise to unscrew the spike fully.
You may find it easier to first remove the
polymer pad to gain more purchase on
the spike.
The pad should be replaced before
carrying out the levelling operation
previously described.
Locking Nut
Main Threaded
Assembly
Soft Polymer
Pad
Spike