Memorex MX3900 - Manual (Page 8)

7
OPERATING INSTRUCTIONS (CONTINUED)
MUTE
To temporarily mute the sound, press the MUTE button on the
remote control; the Mute indicator will appear in the display and the
sound will be muted. Press the MUTE button again to restore the
sound and the Mute indicator will disappear from the display.
1
Press the POWER button to turn
the unit on.
1
Press the TUNING/CD Skip/Search
❶ or ❷ button to select a
station (see Tuning note below).
NOTE: If the FM band is selected
and you have tuned to an FM Stereo
station, the FM Stereo indicator will
light in the display.
1 2
4
Press the TUNER/Band button to
select AM or FM.
NOTE: If you select the FM band,
be sure to extend the FM Wire
Antenna.
3
Press the TUNER/Band button;
“TUNER” will appear in the
display.
2
Adjust the X-BASS (on remote),
EQ ❶ and VOLUME ❷ buttons as
desired.
1
2
5
When you have finished listening,
press the POWER button to turn
the unit off.
6
Hints for Better Reception
FM - Make sure that the FM Wire Antenna is extended to its full length. You may have to vary the direction
of the antenna to find the strongest signal for each FM station.
AM - The AM ferrite bar antenna is located inside the unit. It may be necessary to turn the unit slightly so
that the internal antenna is pointing in the direction of the AM transmitter. You may have to experiment to
find the position that provides the strongest reception for each of your favorite AM stations.
LISTENING TO THE RADIO
TUNING:
MANUAL TUNING: Repeatedly press the TUNING/CD Skip/Search
or to manually advance the
frequency in the display up or down until the desired frequency appears.
AUTOMATIC TUNING: Press and hold the TUNING/CD Skip/Search
or until the frequency in the
display starts to scan, and then release the button; the tuner will search and then stop on the next strong
station it finds. Repeat this procedure until the desired frequency appears in the display.
MX3900.O/M.QXD 4/30/02 11:08 AM Page 7