Morphy Richards Cordless stainless steel kettle - Manual (Page 3)

3
Electrical requirements
Check that the voltage on the rating plate of
your appliance corresponds with your house
electricity supply which must be A.C. (Alternating
Current).
Mains lead length
The correct length of lead should reach from
the socket to the base unit without straining the
connections. Reduce the length of the lead by
storing the excess on the cord storage facility in
the base unit. Do not allow a loop of lead to lie
on or hang over the edge of the work surface.
For appliances supplied with fitted plug
If the socket outlets in your home are not
suitable for the plug supplied with this appliance,
the plug should be removed and the appropriate
one fitted.
Note: The plug removed from the mains lead,
if severed, must be destroyed as a plug with
bared flexible cord is hazardous if engaged into a
live socket outlet.
WARNING: THIS APPLIANCE MUST
BE EARTHED.
Features of your kettle
⁄ Flip top locking lid
¤ Limescale spout filter
‹ Concealed element
› Cordless 360° base unit
fi Cord storage
fl Neon on light
‡ On/off switch (lift up to switch on, press
down to switch off)
· Water level gauge
‚ Cool touch handle
„ Lid release button
‰ Internal and external MAX marks
Instructions for use
1 To fill the kettle press the release button „
to open the flip top lid.
2 Put in at least enough water to cover the
bottom of the kettle but never more than the
maximum (MAX).
3 To close the lid, press the rear of the lid until
it clicks.
Do not operate the kettle with the lid
open or removed. Do not operate without
the spout filter in position.
4 Place kettle on the base unit, engaging the
360° base unit connector. The rotary type
base unit allows you to place the kettle in any
convenient position.
5 Plug in and switch on at the wall socket.
6 Lift the switch lever
‡ to switch on. The
neon ON light will illuminate indicating that
the kettle is working.
7 When the water boils, the kettle will switch
off automatically.
If the kettle is lifted off its base, it will
automatically switch off.
8 To remove the kettle from the base unit,
grasp the handle and hold the kettle level
while lifting it clear of the base unit. Take
extra care if the kettle is filled to MAX.
• If you are using the kettle for the first time,
pour away the boiled water and refill.
• To re-boil, switch to ON again. If the kettle
has just switched off wait a minute or so
before switching if back on again.
If you do not put in enough water, or switch
on the kettle when it is empty, the safety cut-out
will switch off the power automatically. If this
happens, wait a few minutes for the element to
cool, then refill and use as normal.
¤
‚
·
fi
›
‹
‰
⁄
fl
‡
„