Meco 67A4T09K21 - Manual (Page 9)

9
Step 6
Side Table Assembly
A. Locate the two 1/4-20 x .50” Bolts in the two bottom threaded inserts on the outside of the Bowl. Uncrew Bolts
about halfway.
Align the bottom two holes (“keyhole slots” in detail) on the inner side of the LEFT Side Table with the two bolts thread-
ed partly into the inserts in the Side of the Bowl then slide the Side Burner Table over the Bolts.
B. Holding the Side Burner Table in place, install two 1/4-20 x .50” Bolts from the inside of the Bowl into the two top
threaded holes in the Side Table.
C. From under the Side Table, install one 5/32 x .31” bolt through the Side Table end into the side of the Bowl. Tighten
all bolts.
Repeat this assembly for the RIGHT Side Table.
1/4-20 x .50” Bolt set
4 pcs
Prior to performing any further assembly, PERFORM “FIRST TIME USE” LEAK TEST
as detailed on pages 16-17.
If the grill is fully assembled before performing the First Time Use leak test, the side tables will need to be removed in order to perform the
leak test on the main burner valves inside the control panel, behind the knobs, .
CAUTION
!
5/32 x .31” Bolt set
2 pcs
5/32 x .31” Bolt
A
Keyhole Slots
B
C
A