Metra Electronics 99-5720 - Manual

KIT COMPONENTS
KIT FEATURES
Shaft and
DIN unit
provisions
Various
mounting depth
alternatives
Incorporates
factory climate
controls into
installation
APPLICATIONS
CAR PAGE
FORD
Escort 1997-04
Escort ZX2 1998-04
MERCURY
Tracer 1997-99..................................1-3
* Note: Metra’s 70-5720 must be used on 2003-04 Zx2 and Escort Models
TOOLS REQUIRED
Cutting tool
Torx-head screwdriver
86-5618 - Head unit
removal keys
99-5720
INSTALLATION
INSTRUCTIONS
3
DIN HEAD UNITS: Slide the DIN cage into the Integrated Mounting Kit and secure by bending
the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B)
7
Fig. B
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001-07 METRA ELECTRONICS CORPORATION Rev. 12-21-07
6
Locate the factory wiring harness in the
dash. Metra recommends making
connections as shown using the
supplied wire harness. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Right Front + ...............Gray
Right Front - ................Gray/Black
Left Front + ..................White
Left Front - ...................White/Black
Right Rear + .................Violet
Right Rear - ..................Violet/Black
Left Rear + ...................Green
Left Rear - ....................Green/Black
12 Volt Power................Red
Memory..........................Yellow
Ground..........................Black
Power Antenna.............Blue
Dimmer..........................Orange/White
Amp Turn-On................Blue/White
NOTE: Ground head unit to vehicle
Speaker
Harness
Integrated
Mounting Kit
ZX2 2003-04*......................................1-3