Magnadyne X9 - Manual (Page 6)

Press Buttons at the Same Time: Then Press Button Within: System Function
5 Sec.
Switching to 2nd Vehicle
or Returning to 1st
Vehicle Operation
5 Sec. Melody / Vibration Mode
5 Sec. Power Save Mode
LCD Screen Lamp
Turns On for Five Seconds
3 Sec. System Status Check
3 Sec.
Clear the Flash Icon
and Melody Sound
6
+
+
+
+
+
The LCD remote control is powered by a 1.5 Volt AAA
Alkaline battery. When the power of the battery
weakens the battery icon will be displayed on the
screen. When the old battery is replaced with a new
one, there will be a beep to indicate the power is up. To
replace the battery, follow the steps in the illustration
at left.
Note: Press the button two times when the battery
compartment is empty, then insert the new battery.
The transmission range may decrease if the system encounters interference from tall structures or
stronger radio frequencies such as high-voltage power lines.
LED Function
OFF System is Disarmed
Slow Flashing System is Armed
Fast Flashing System in Automatic Arming
1 Flash Every 5 Seconds System in Valet Mode (Ignition Key On or Off)
2 Flashes - Pause Zone 2, Trigger on Trunk/Hook
3 Flashes - Pause Zone 3, Trigger on Door Switch
4 Flashes - Pause Zone 4, Trigger on Shock Sensor
5 Flashes - Pause Zone 5, Trigger on Ignition Switch
LCD Remote Programming
Battery Replacement (Applies to LCD Transmitter Only)
Interference
LED Indicator