Mellerware 23810 User Manual

Page 6

Breakdowns

Causes

Solutions

Water drips
from the
holes on the
base of the
iron when
turning on
the steam
switch (H).

Iron thermos-
tat control (J)
set to the mi-
nimum posi-
tion "·""··".

Set the thermostat
control to the
steam zone "···".

The boiler is
too full.

Remove some
water.

The boiler
is in a tilted
position.

Place it on a
horizontal sur-
face.

The iron does
not heat and
the LED (K)
does not light
up.

The switch

Switch it to
“on” (A).

Iron ther-
mostat con-
trol (J) set to
the minimum
position.

Adjust the ther-
mostat control.

Faulty power
connection.

Check the power
points.

No steam co-
mes out
when pres-
sing the
steam switch
(H).

Empty boiler. Fill the boiler

with water.

Switches (B)
and (A) are

Switch them
on.

Leak

from the

cap (F).

Cap (F) not
properly clo-
sed.

Let the boiler cool
and screw the cap
(F) to the end
again.

The boiler cap
(F) does not
unscrew easi-
ly.

There is
steam re-
maining in-
side the
boiler.

Press the steam
switch (H) to let
the steam out.

Safety valve
activated.

Go to an authori-
zed Technical
Service.

MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 6

7/15/2009 4:32:44 PM