MTD E600E - Manual (Page 5)

5
SECTION 4: LOOSE PARTS & HARDWARE PACK
IMPORTANT: After assembly, service engine with
gasoline, and check oil level as instructed in the sep-
arate engine manual packed with your unit.
UNPACKING
1. Remove staples or break glue on the top flaps of
the carton. Remove any loose parts included with
unit (i.e., Operator’s Manual, etc).
2. Cut along corners and lay end of carton down
flat. Remove packing material.
3. Roll unit out of carton. Check carton thoroughly
for loose parts before discarding.
TOOLS REQUIRED FOR ASSEMBLY
• Pair of pliers
• Two adjustable wrenches
CONTENTS IN CARTON See Figure 3
• Right and Left Handles
• Handle Panel Assembly
• Chute Assembly
• Chute Directional Control Assembly
• Shift Rod
• Hardware Pack
Figure 3
Handle Panel Assembly
Handles
Chute Directional
Control Assembly
Shift Rod
Chute
Assembly