Miele EGW602-14 - Manual (Page 17)

Adhering the insulation strips
^ Remove the protective foil from the
adhesive strips.
^ Align the metal strips flush against
the side and rear walls of the cabinet
a and stick them on to the plate
warmer
b (see illustration).
The third metal strip is not needed if the
cabinetry does not have a rear panel.
^ Install the combination appliance in
accordance with its own specific op-
erating/installation instructions and
then connect the electrical supplies.
Aligning the front of the plate warmer
After installing the combination appli-
ance, it may be necessary under cer-
tain circumstances to
– align the front of the plate warmer.
– align the gap between the plate
warmer and the combination appli-
ance.
To help you do this, there are adjusting
points underneath the nuts which se-
cure the drawer to the telescopic run-
ners.
^ Loosen the nuts and take the plate
warmer drawer out.
Use the adjusters to align the drawer
correctly.
Installing the plate warmer
17